Add Room Elements

To add room elements to your planogram:

1. Switch to the Room task.
2. Drag new elements to the viewing area.

The following room elements are available:

• Floor: an element with 1 material on the top surface. By default floors are 600 × 600 cm (or equivalent), have no bottom surface and no thickness. Combine several floor elements to create non-rectangular sales floors.
• Wall: an element with a material on its 2 sides. By default walls are 600 × 300 cm (or equivalent) and have no thickness. You can combine multiple walls to create any room type.
• Ceiling: an element with 1 material on the lower surface. By default ceilings are 600 × 600 cm (or equivalent), have no top surface and no thickness. You can combine several ceiling elements to create non-rectangular rooms.
• Box: an element with 1 material applied to all sides. By default boxes are 100 × 100 × 100 cm.

For a rectangular room, start by putting a floor, and then add walls and a ceiling.

To create more complex rooms, you can combine several floors, walls and ceilings and use boxes to create other structural elements such as columns or obstacles.

 

When dragging each new element, PlanogramBuilder tries to position, orient and dimension it to match the existing elements. For example, dragging a new wall close to a floor edge puts the new wall at the edge of the floor and matches the floor edge length.

Note: you can resize room element, including adding thickness.

Tip: If you want to re-use a room in other planograms, save the room as a project and make it a Template available in the Template Catalog to drag into any other planogram. 

 

Example of a simple room